axial outlet

英 [ˈæksiəl ˈaʊtlet] 美 [ˈæksiəl ˈaʊtlet]

网络  轴出口

机械



双语例句

  1. Research on the Aerodynamic Performance of a New Type of Burner with Gear Axial Air Outlet
    新型齿结构三通道喷燃器空气动力特性研究
  2. The level of suction pumps for the axial direction, pump discharge outlet may be fitted into the needed horizontal or vertical direction.
    泵吸入口为轴向水平方向,泵排出口可根据需要装成水平或垂直方向。
  3. Under the scope of the investigation, axial velocity distribution uniformity on the outlet section is improved and the velocity-weighed average bias angle decreases with the increase of flow rate.
    在所研究的范围内,随着流量的增加,出口断面轴向速度分布均匀度提高,速度加权平均偏流角减小;
  4. Study on the Numerical Simulation of the Influence of the Outlet Circulation of Axial Flow Pump to the Hydraulic Loss of the Outlet Conduit
    轴流泵出口环量对出水流道损失影响的数值模拟研究
  5. It is also discovered that the axial velocity distribution and velocity-weighted average swirl angle at the outlet section of axial-flow pump vary with the changing of wall roughness.
    研究还发现,水泵出口断面轴向流速分布均匀度和速度加权平均偏流角也随壁面粗糙度改变而改变。
  6. Noise level as high as 113dB ( A) generated by air current of axial flow fan at the outlet of ventilation shaft of a coal mine poses big environment problems.
    煤矿风井轴流风机气流速度大,扩散口噪声辐射强度高达113dB(A),降噪难度较大的低频成份突出。
  7. The distribution of time-averaged axial velocity in the outlet tube was very different from that in the separation space.
    排气管内轴向速度分布与分离空间内的分布形态迥异。
  8. The predicted results of the wall pressure distribution, axial velocity profiles at the outlet and the spray angle agreed well with the experimental datum.
    计算得到的壁面压力分布、出口处液膜内轴向速度分布以及雾角大小都与实验结果吻合的很好。
  9. Progress of axial pump The outlet passage of reversible pumping system, which is a special type of pump, invented by Chinese researcher.
    轴流泵研究进展双向轴流泵装置是一种特殊的泵站形式。
  10. Upstream boundary conditions are determined by inlet axial velocity and the influence of blades on the upstream and downstream boundary conditions-by equal-circulation change in absolute velocity in outlet range.
    根据叶轮进口轴向分速和叶片对上游的影响确定上游过界条件,下游边界条件根据绝对速度等环量变化确定。
  11. Mathematical models are presented to express the characteristics based on the systematical analysis of electromotor, axial pump and outlet conduit dynamic characteristics, and numerical calculation methods are promoted.
    从理论上分析了泵系统启动及事故停泵过渡过程中电动机、轴流泵及流道的过渡过程特性,建立了描述其启动及停泵过程的数学模型。
  12. The flow field analysis shows that the gas-liquid separating efficiency is not satisfied with the bad axial symmetry of the flow field and high gas content near the underflow outlet.
    通过流场分析可以看出,流场对称性很差,底流出口附近气体含量较多,说明气液分离效果不好。
  13. Based on flow field computation method, their realized methods were studied according to engineering requirements, including processing all kinds of functional curves, visualization of axial velocity for outlet section and other sections as well as reprocessing and display of 3D computation grids.
    文中基于流场数值计算方法,根据工程实际需要,研究其相应的可视化实现方法,主要内容包括各种函数关系曲线处理、流道出口及任意断面轴向流速可视化及三维计算网格再处理和图形显示等。
  14. This paper describes the influences of such factors as axial speed, outlet pressure and media on the suction performance of three screw pump, and tells about the methods of and basis on how to decide cavitation point during test.
    文章阐述了轴向速度、排出压力、介质等因素对三螺杆泵吸上性能的影响,并介绍了试验时判定发生汽蚀工况点的方法和依据。
  15. Therefore, the arbitrary vortex design method can have a more well-distributed axial speed at outlet of fan system by regulating the rotate speed distribution. The more well-distributed speed of the fan exit can improve the aerodynamic performance of diffuse section.
    因此,随意涡设计方法中可以通过调整旋转速度分布使风扇系统出口轴向速度分布更加均匀一些;这对提高下游扩散段的气动性能是有帮助的。